MOLD!!!!!!!!!!!???????????
64 posts • Page 1 of 5 • 1, 2, 3, 4, 5
MOLD!!!!!!!!!!!???????????
Hello everyone, I went to get my Guoyan 66 today to have a drink and when I stuck the knife in the side and began lifting a section out of the cake there was this yellow powdery substance stuck to the leaves, first thing I though was mold. But this substance is only on the parts that I have flaked from. The top of the cake that has not been touched is fine. Here are some pics, kinda hard to see because its a rather small object to capture, but tell me what you think. And if anyone else has this cake, check yours to see if maybe you have the same thing, because it could just be a manufacturing thing or fuzz from the leaves, IDK? Until now all tea is out of the pumidor and this tea has been separated and will not be consumed.


-

shogun89 - Posts: 1636
- Joined: Feb 15th, '
- Location: Pennsylvania
Hey Shogun,
The yellow mold variety is the bad stuff so you may want to chunk it. As for it being a factory flaw, it may well have been. Mold inside the beeng is typically a consequence of the manufactuer not throughly drying the been before packaging. The water trapped inside the beeng is then subject to cause decay. However, too much humidity with insufficent venilation can also contribute to internal deterioration. If beeng absorb more moisture than they can expell through the process of evaporation then again, deterioration can happen. Since the surface of the beeng is exposed to more to air the suface of the beeng is more likely to stave off any infection.
hop
The yellow mold variety is the bad stuff so you may want to chunk it. As for it being a factory flaw, it may well have been. Mold inside the beeng is typically a consequence of the manufactuer not throughly drying the been before packaging. The water trapped inside the beeng is then subject to cause decay. However, too much humidity with insufficent venilation can also contribute to internal deterioration. If beeng absorb more moisture than they can expell through the process of evaporation then again, deterioration can happen. Since the surface of the beeng is exposed to more to air the suface of the beeng is more likely to stave off any infection.
hop
-

hop_goblin - Posts: 1937
- Joined: May 22nd, '
- Location: Trapped inside a bamboo tong!
heavydoom wrote:at least try it and see what the taste is like.
No, don't try it. Yellow mold should always be considered as toxic.
-

hop_goblin - Posts: 1937
- Joined: May 22nd, '
- Location: Trapped inside a bamboo tong!
So what does all this mean? Can it be revived or tested somehow or is it just safe to call it dead? If it is dead I cant really be that mad as it only cost me $10 but still. All the other cakes look fine which is the good news. This is the exact reason why I would never put my Bai Cha Tang cakes in the pumidor, Too much to risk.
-

shogun89 - Posts: 1636
- Joined: Feb 15th, '
- Location: Pennsylvania
Zoiks, that's too bad.. Sorry to hear it. It's hard to tell from the pics, so I'm just going on what you say. If it's only on parts that have been flaked off, could it also be related to contamination from touching the cake?
Anyway.. I'm going to spot-check some of my cakes now!
Anyway.. I'm going to spot-check some of my cakes now!
-

Dizzwave - Posts: 330
- Joined: Feb 27th, '
- Location: Portland, OR
I think several of us were concerned that this would happen. Its just too risky. Sorry about your pu loss.
-

puerhking - Posts: 544
- Joined: Jul 7th, '0
- Location: I have no idea
I really dont think this is the pumidor's fault. I dont even know if it is mold and how to find out.
-

shogun89 - Posts: 1636
- Joined: Feb 15th, '
- Location: Pennsylvania
Eat some. If you're dead , it's mold. Pls have your parents let us know how it went, just in case.shogun89 wrote: I really dont think this is the pumidor's fault. I dont even know if it is mold and how to find out.
-

Salsero - Posts: 5214
- Joined: Dec 21st, '
- Location: Gainesville, Florida
Salsero wrote:Eat some. If you're dead , it's mold. Pls have your parents let us know how it went, just in case.shogun89 wrote: I really dont think this is the pumidor's fault. I dont even know if it is mold and how to find out.
Sal, you are incorrigible!
-

hop_goblin - Posts: 1937
- Joined: May 22nd, '
- Location: Trapped inside a bamboo tong!
dosent boiling water kill mold???
What do you guys think, Should I just brew some up? If it really is mold what will happen to me??
What do you guys think, Should I just brew some up? If it really is mold what will happen to me??
-

shogun89 - Posts: 1636
- Joined: Feb 15th, '
- Location: Pennsylvania
you won't die instantly. at least in the states, you can dial 911 and be airlifted to the nearest high tech hospital within literally seconds.
i think you should at least try to have a swirl inside your mouth.
we need to bring in chrl42 here, he seems to know the solutions to all our problems.
all hails to chrl42!!!
i think you should at least try to have a swirl inside your mouth.
we need to bring in chrl42 here, he seems to know the solutions to all our problems.
all hails to chrl42!!!
-

heavydoom - Posts: 521
- Joined: Jun 1st, '0
- Location: The Golden Horseshoe
heavydoom wrote:you won't die instantly. at least in the states, you can dial 911 and be airlifted to the nearest high tech hospital within literally seconds.
i think you should at least try to have a swirl inside your mouth.
we need to bring in chrl42 here, he seems to know the solutions to all our problems.
all hails to chrl42!!!
I dont really want to be airlifted all because of a $10 tea. But I sure as hell dont want to waste the tea.
-

shogun89 - Posts: 1636
- Joined: Feb 15th, '
- Location: Pennsylvania
64 posts • Page 1 of 5 • 1, 2, 3, 4, 5